DRBD2, OCFS2, Unexplained crashes

I was trying to setup a dual-primary DRBD environment, with a shared disk with either OCFS2 or GFS. The environment is a Centos 5.3 with DRBD82 (but also tried with DRBD83 from testing) .

Setting up a single primary disk and running bonnie++ on it worked Setting up a dual-primary disk, only mounting it on one node (ext3) and running bonnie++ worked

When setting up ocfs2 on the /dev/drbd0 disk and mounting it on both nodes, basic functionality seemed in place but usually less than 5-10 minutes after I start bonnie++ as a test on one of the nodes , both nodes power cycle with no errors in the logfiles, just a crash.

When at the console at the time of crash it looks like a disk IO (you can type , but actions happen) block happens then a reboot, no panics, no oops , nothing. ( sysctl panic values set to timeouts etc )
Setting up a dual-primary disk , with ocfs2 only mounting it on one node and starting bonnie++ causes only that node to crash.

On DRBD level I got the following error when that node disappears

  1. drbd0: PingAck did not arrive in time.
  2. drbd0: peer( Primary -> Unknown ) conn( Connected -> NetworkFailure )
  3. pdsk(UpToDate -> DUnknown )
  4. drbd0: asender terminated
  5. drbd0: Terminating asender thread

That however is an expected error because of the reboot.

At first I assumed OCFS2 to be the root of this problem ..so I moved forward and setup an ISCSI target on a 3rd node, and used that device with the same OCFS2 setup. There no crashes occured and bonnie++ flawlessly completed it test run.

So my attention went back to the combination of DRBD and OCFS
I tried both DRBD 8.2 drbd82-8.2.6-1.el5.centos kmod-drbd82-8.2.6-2 and the 83 variant from Centos Testing

At first I was trying with the ocfs2 1.4.1-1.el5.i386.rpm verson but upgrading to 1.4.2-1.el5.i386.rpm didn't change the behaviour

Both the DRBD as the OCFS mailinglist were fairly supportive pointing me out that it was probably OCFS2 fencing both hosts after missing the heartbeat, and suggested increasing the deathtimetimeout values.

I however wanted to confirm that. As I got no entries in syslog I attached a Cyclades err Avocent Terminal server to the device in the hope that I'd capture the last kernel messsages there ... no such luck either.

On the OCFS2 mailinlist people pointed out that i'd use netconsole to catch the logs on a remote node
I set up netconsole using

  1. modprobe netconsole netconsole="@/,@"
  2. sysctl -w kernel.printk="7 4 1 7"

After which indeed I catched error on my remote host..

  1. [base-root@CCMT-A ~]# nc -l -u -p 6666
  2. (8,0):o2hb_write_timeout:166 ERROR: Heartbeat write timeout to device
  3. drbd0 after 478000 milliseconds
  4. (8,0):o2hb_stop_all_regions:1873 ERROR: stopping heartbeat on all active
  5. regions.
  6. ocfs2 is very sorry to be fencing this system by restarting

One'd think that it output over Serial console before it log over the network :) It doesn't .

Next step is that I`ll start fiddling some more with the timeout values :) (note the ":)")